Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Box Fan Anti-Tip Outrigger Corner Foot
This corner shoe replaces the snap-in feet that break off cheap 20 in box fans. The fan's bottom corner sits in a 56 x 55 mm floor with a 45 mm side wall and a 30 mm front lip. A 25 mm gusseted outrigger widens the stance so the fan is harder to tip over. Two pairs of 2.5 x 7 mm slots let a standard 4.8 mm zip tie go through the front grille, and a 3.8 mm horizontal slot takes an optional #6 screw into the housing. Print two as modelled and two mirrored in the slicer for all four corners.
Tongue Jack Flex-Fin Ground Foot Shoe
A 100 mm wide replacement ground shoe for trailer tongue jacks with a cracked or missing plastic foot. Eight angled flex fins inside a 56 mm socket grip round jack feet or inner tubes from 44 to 52 mm. Eight gussets carry the load into the base, there is an 8 mm drain hole, and four 5.5 mm holes let you lag-screw or stake it to a plywood pad.
Generator Frame Tube Hose-Clamp Foot
This replaces the cracked plastic foot on a portable generator's wheel kit or tube frame. A 90° V-saddle sits on any round frame tube from 19 to 32 mm OD and lifts it 40 mm off the ground. Two 1/2 in (12.7 mm) worm-drive hose clamps strap it on through 13 x 3 mm tunnels. The 70 x 56 mm hollow ring base takes the generator's weight in compression.
Teak Shower Bench Screw-On Drain Foot
A replacement foot for teak shower benches and stools whose original wooden foot has snapped off. The foot is 56 mm across at the floor and steps up to a 44 x 44 mm leg pad, 20 mm tall. Fix it with four #8 wood screws in 9.5 mm counterbores, or one M5 hanger bolt through the 5.5 mm centre hole. Cross drain channels under the foot let water run out instead of sitting against the end grain.
Bathroom Scale Split-Stem Replacement Foot
Replacement foot for bathroom scales that have lost a foot. It is a 32 mm round pad with a split, barbed stem (11.5 to 9.5 mm barbs) that snaps into the scale's empty socket. An optional M4 screw can go in from below to lock it. A 26.4 x 1 mm recess underneath takes a 25 mm felt or rubber bumper. Overall height is 26 mm.