Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Raccoon-Proof Bin Lid Snap Latch
A latch that bolts to the outside of a trash or storage bin and holds the lid down. A 3 mm flexing beam with a 10 mm catch tooth snaps over the lid edge, and a pull tab lets a human open it. Two M5 bolts go through a 36 mm wide, 6 mm thick back plate, and each bolt column has three holes (24, 32 and 40 mm up) so you can match the height of your lid rim.
Kitchen Trash Can Bag Rim Lock Clip
A 40 x 20 x 25 mm snap clip that holds a trash bag over the rim of a kitchen bin, so the liner stops slipping down into the can. It prints flat, so its flexible outer leg bends in the strong layer plane. The mouth is 6 mm wide and closes to a 2 mm barb, so it grips rims about 1.5–5 mm thick with the bag film folded over. Ridges on the inner leg bite into the bag, and a thumb tab pries it off.
Step Can Pedal Rocker Arm
Replacement rocker/bell-crank arm for the foot-pedal linkage in a step trash can (Simplehuman-style 30 L round cans and their clones), the one plastic lever that always snaps and that nobody sells as a service part. 98.7 mm long with a 5.5 mm pivot bore for a 5 mm pin or M5 bolt, two 4.5 mm pedal-rod holes 9 mm apart to re-tune pedal throw, and an open C-socket at the lift end that clips over a 4 mm lid rod; 10 mm tall bosses and a full-length spine rib carry the load in the print plane. Measure your can's pivot pin before printing — holes are sized to standard 4 mm / 5 mm pins.