Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Desk-To-Wall Standoff Cable Trough
This part screws under the back edge of a desk with two #8 wood screws (4.2 mm shank, through 4.8 mm slots with 22 mm of travel). Its 6 mm-wide bumper keeps the desk about 40 mm off the wall, so the desk can't slide back, crush plugs or scuff the paint. Between the desk and the wall it forms a 28 x 23 mm cable trough with a 12 mm snap-in opening that runs the length of the desk.
Crush-Rib Garage Wall Door Bumper
This wall guard is 80 x 30 x 120 mm and screws flat to garage drywall or a stud where your car door swings open. It has a zigzag core of 2 mm leaf ribs that bends when the door edge hits, so neither the paint nor the wall gets dinged. It mounts with two #8 wood screws (4.2 mm shank) through 4.8 mm clearance holes. The screws are driven through 10 mm access holes in the front pad, and the part prints standing up so impact loads run across the ribs, not the layer lines.