Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Snowblower Sled-Runner Skid Shoe
A replacement skid shoe for a snowblower auger housing. It has a 130 mm sled runner, 22 mm wide and 7 mm thick, that turns up at both ends so it glides over gravel and pavement cracks instead of digging in. The two vertical adjustment slots are 9 mm wide, fit 5/16 in or M8 bolts, sit 70 mm apart by default and give 21 mm of height travel. Measure your old shoe's hole spacing and set BOLT_SPACING to match it.
Mini-Sumo Bolt-On Sacrificial Wedge Blade
A replaceable front wedge blade, 96 mm wide, for 10 x 10 cm mini-sumo robots. It has a 1.2 mm scraping tip, a 25° ramp and a 24 mm tall back plate that bolts to the chassis front with two M3 screws, 50 mm apart, through height-adjust slots with 4 mm of travel. When the tip wears or chips after a match, you swap this part instead of reprinting the whole chassis, and the slots let you set the tip back to ground contact.
Flagged: a sharp edge or blade. Not for safety-critical use without independent engineering review.