Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
M5 Screw-Driven Wedge Leveling Mount
A two-piece leveling mount: a 90 x 49 mm base with a 10° ramp, plus a 46 x 40 mm wedge slider that an M5 bolt pushes along the ramp through an 8.4 mm captured-nut pocket. It gives about 6 mm of fine, lockable height adjustment under benches, machines and cabinets. The base screws down through two 4.5 mm (M4 or #8) ear holes, and the slider's flat 40 mm top pad carries the load.
Three-Step Mixing Bowl Tilt Chock
A curved, stepped chock that goes under one side of a mixing bowl's foot ring. Its treads sit at 10, 18 and 26 mm and a 32 mm back lip stops the bowl, so you can whisk, scrape or pour at three fixed tilt angles without holding the bowl. The arc runs from 55 to 96 mm radius and is about 110 mm wide, so it follows the foot ring of most 150–300 mm bowls. A hollow channel with a 45° peaked roof keeps the material down and prints without supports.
Mini-Sumo Bolt-On Sacrificial Wedge Blade
A replaceable front wedge blade, 96 mm wide, for 10 x 10 cm mini-sumo robots. It has a 1.2 mm scraping tip, a 25° ramp and a 24 mm tall back plate that bolts to the chassis front with two M3 screws, 50 mm apart, through height-adjust slots with 4 mm of travel. When the tip wears or chips after a match, you swap this part instead of reprinting the whole chassis, and the slots let you set the tip back to ground contact.
Flagged: a sharp edge or blade. Not for safety-critical use without independent engineering review.
Wheelbarrow Tub Support Wedge Block
A replacement for the plastic wedge that sits between a wheelbarrow tub and its handle rail. It is 90 x 40 mm and tapers from 18 to 38 mm tall (a 12.5° pitch). Underneath is a 26 mm wide 90° V-saddle that seats on round steel handle tubes about 25–40 mm across or on the edges of a wooden rail. The through-slot is 6.8 x 20.8 mm, so a 1/4 in or M6 tub bolt lines up even when the original hole spacing varies. The ribbed top has open pockets to save material.
Video Doorbell 30 Degree Wedge
A 30° horizontal-aim wedge that sits between a video doorbell or small security camera and the wall, swinging the field of view across an offset walkway or corner entry — 46 mm wide, 84 mm tall, tapering from 5.2 mm to 31.8 mm deep. Six 4.5 mm through-holes on the centreline (M4 or #6 screws) give nine bracket spacings from 28 to 68 mm, a 26 x 16 mm pass-through carries the bell wires, and the hollow shell is symmetric so flipping it end-for-end aims the other direction.