Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Shower Chair Flex-Fin Draining Leg Tip
This is a replacement foot for shower chairs and bath benches. It fits round aluminium leg tubes from 22 to 26 mm OD, which covers both 7/8 in and 1 in tubes. Six angled flex fins grip the tube, and a centre drain hole with three underfloor channels lets water out of the leg. The foot is 48 mm across, 36 mm tall and has a 31 mm deep socket. It replaces the cracked brand-specific tips that medical suppliers sell for $8–12 each, and you can stick an anti-slip pad to the flat base.
Barbed Drain Hair Snake With Ring Grip
This is a flat barbed strip that you push down a clogged shower, tub or sink drain and pull back out with the hair caught on it. The working strip is 7 mm wide and 1.8 mm thick, and its 18 backward-hooked barbs reach out to 13.6 mm across. The whole tool is 172 mm long and ends in a 36 mm ring grip that also works as a hanging loop. Print it in PETG if you want more flex down tight bends; you don't need a plumber or a chemical drain cleaner.
Slotted 2-3 in Tub Overflow Cover Plate
This is a 92 mm round blank cover plate for a tub overflow. It replaces a cracked or discontinued trip-lever faceplate, or covers the hole after you switch to a toe-tap or lift-and-turn drain. Its slotted screw holes (5.5 mm wide, counterbored for pan heads) fit any screw spacing from 2 in (50.8 mm) to 3 in (76.2 mm). On the back, a 9 mm stand-off skirt with inlet notches at the bottom keeps the overflow path open. Print it in PETG, face-down.
Shower Drain Hair Catcher Dome
A 92 mm diameter, 30 mm tall slotted cone that sits over a standard round shower drain grate and traps hair on the outside where you lift it off and wipe it clean, instead of letting it braid into the trap. Thirty 2.6 mm slots pass the water, a 2.5 mm base ring keeps it from rocking, and the 5.5 mm centre bore drops over the grate's existing screw (M5, #8-32 or #10-24) so it cannot slide or float away; the 14 mm knob is the lift handle.