Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Wall-Mount Bath Mat Drying Saddle Rack
An open-grid saddle that screws to the wall. You fold a damp bath mat or hand towel over it so air reaches both sides, instead of leaving it soaking on the tub edge. It is 120 mm wide with a 100 mm reach and a 26 mm rear-curl lip so the mat stays put. Three gusseted fins carry the load in the layer plane, and it mounts with four #8 (4.2 mm) wood screws through 4.8 mm clearance holes set below the arm so a screwdriver can reach them.
Bristle-Down Makeup Brush Drying Rack
A stand for the vanity counter or a wall that hangs up to five washed makeup brushes bristle-down, so water runs out of the bristles and doesn't soak the glue in the ferrule. Each tapered V-slot narrows from 15 mm to 4.5 mm, so any handle in that range slides in and wedges without needing a set size. The rack is 140 x 130 mm with a 60 mm vented foot. It prints flat on its back with no supports, and two 4.5 mm holes take #6 wood screws if you want it on the wall.