Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Ceiling Airer End Frame For 1/2 in EMT
One end frame for a pulley ceiling airer that hangs over a bath. Print two, slide five 1/2 in EMT rails (17.9 mm OD) through the 18.3 mm bores, and you have a towel and laundry rack that you raise and lower on a cord tied to the 10 mm rope eye. The frame is 170 x 99 mm with 22 mm deep rail collars at a 34 mm pitch. Each collar has a 4 mm side hole so you can pin the rail with a #6 self-drilling screw.
1/2 in EMT Clawfoot Shower Rod Drop Tee
A set-screw tee for DIY clawfoot tub shower curtain rods made from 1/2 in EMT conduit (17.9 mm OD). The horizontal curtain rail passes straight through an 18.3 mm bore, and the vertical ceiling drop sits 30 mm deep in a top socket. Three M4 self-tapping set screws (3.4 mm pilots) lock both tubes. The body is 50 x 28 x 60 mm, and the rail bore has a teardrop top so it prints without supports.