Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Tub Lip Screw-Clamp Draining Soap Ledge
A drill-free soap and razor ledge that clamps over the rim of a freestanding, clawfoot or drop-in tub. An M5 screw runs through a captured nut and closes on any rim from about 4 to 38 mm thick, with a 30 mm deep jaw. The 56 x 70 mm tray drains through twelve 4 mm holes, has a 15 mm front lip, and two gussets carry the load into the inner jaw. It prints flat on its side, so the clamp loads stay in the layer plane.
1-1/4 in Grab Bar Saddle Soap Dish
This soap dish snaps onto a standard 1-1/4 in (31.75 mm) shower grab bar, so you don't have to drill new holes in the tile. The clip has a 32.2 mm bore and wraps 240° around the bar at both ends. The ribbed 72 x 80 mm tray sits directly above the bar, so the soap's weight doesn't twist it. Six drain slots let water run straight down onto the bar.
Frameless Shower Door Saddle Hook
A clamp-on double hook that saddles the top edge of a frameless glass shower door — towel hook on the outside, loofah/razor hook on the inside, no drilling, adhesive or suction cup. The 13.6 mm slot with a raised grip pad takes 6–13 mm (1/4"–1/2") tempered glass, and an M4 heat-set insert (5.5 mm bore) plus an M4x16 screw locks it down; 76 x 43 x 26 mm.