Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Bath Fan Motor Retrofit Slotted Adapter Plate
A 150 x 80 mm ribbed adapter plate for mounting a universal replacement bath-fan motor in the original fan housing when the bolt holes don't line up. It has 4.5 mm slots for #8 / M4 screws: four radial motor slots cover 44–76 mm across on X and 44–64 mm on Y, and two end slots reach housing holes 96–140 mm apart. A 34 mm centre bore clears the shaft and hub, and 10 mm edge ribs keep it stiff.
1-1/4 in Grab Bar Toilet Roll Arm
This U-saddle drops onto a standard 1-1/4 in (31.75 mm) grab bar and is locked in place by an M4 screw. It carries a 115 mm cross-fin spindle that sits 80 mm off the bar axis, so a standard roll (42 mm core, up to about 120 mm OD) hangs clear of the bar and the wall. It lets you put the toilet paper where a seated user can reach it, with no new holes in tile and no need to trust a second set of wall anchors.
Snap-On Interior Door Bottom Sweep Clip
A 120 mm U-channel segment that pushes onto the bottom edge of a 33–37 mm interior door (standard 1-3/8 in / 34.9 mm hollow-core) and holds itself on with angled flex fins. Its barbed lower jaw grips a 3–4 mm strip of rubber, EPDM or felt, which closes the light, sound and draft gap under a bathroom door. Butt segments end to end across the door and saw the last one to length. Optional 4 mm holes take #6 screws for a permanent fit.