Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Towel Ring Screw-Closed Wall Post
This is a replacement wall post for a bathroom towel ring whose small retaining tab has snapped. The top of the ring drops into a 10 mm wide open-top cradle (fits ring wire or tube up to about 9 mm), and an M4 screw across the mouth locks it in. It mounts with two #8 pan-head wood screws through 4.8 mm holes 62 mm apart. It is 56 mm deep, 80 mm tall and 22 mm wide, and it prints on its side so the towel load runs along the layers, not across them.
Heated Towel Rail V-Block Wall Bracket
A wall standoff bracket for ladder-style heated towel rails whose own clip has snapped. A 90° V-block self-centres any upright tube from 20 to 32 mm diameter, and a worm-drive hose clamp or heavy zip tie (bands up to 14 mm wide) through the slot behind the V pulls the tube tight. The bracket holds the tube centre 59–68 mm off the wall, is 70 x 57.5 x 32 mm, and screws up with four #8/#10 or M5 wood screws through 5.5 mm holes. Electric rails run warm, so print it in PETG or ASA rather than PLA.