Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Adhesive Shower Caddy Screw-Down Hook Plate
This screw-down plate replaces the failed adhesive hook on a wire or plastic shower caddy. It has a 12 mm top hook channel for the caddy's hanger loop or slot and an 8 mm bottom J-channel that catches a 3–7 mm back rail to stop swaying. It measures 50 x 90 mm with a 22 mm projection, fixes with four countersunk #8 or M4 screws (4.6 mm holes) into anchors or tile plugs, and prints on its side so the hook load runs along the layers instead of across them.
Sink Plug Parking Peg With Chain Notch
A wall-screwed peg that holds a loose sink or bath plug off the basin. The 25 mm peg with its 18 mm up-turned lip holds the plug, and a 3 mm notch in the lip catches the bead chain. The 30 x 75 mm plate takes two 4.5 mm countersunk holes for #6/#8 wood screws or M4, and a 45° rib under the peg carries the load across the layers.
Fork-Cradle Shower Squeegee Wall Hanger
This screw-on wall hanger holds a shower squeegee on two forked arms. The handle drops through a 22 mm gap, and the blade sits in a 34 mm-deep cradle with a lip that stops it sliding off. It takes handles up to 22 mm thick. The part measures 45 x 70 x 46 mm and fixes to the wall with two #8 wood screws or M4 screws through 4.6 mm holes that are 50 mm apart. It prints on its side, so the arms carry the load along the layers and not across them.