Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Glovebox Hinge Rebush Kit For 5 mm Pin
A sprue-frame kit for fixing sagging glovebox and console lids. You drill each worn, oval pivot hole out to a round 10 mm and press in a flanged bushing (9.8 mm body, crush ribs to 10.4 mm, 14 mm flange). A 5 mm steel rod then serves as the new hinge pin, in a 5.3 mm slip-fit bore, and two push-on collars hold the rod in place. The kit is four bushings and two collars on a 109 x 24 mm frame.
Mower Wheel Axle Bushing Set
A snap-apart run of three split flanged sleeve bushings for worn mower, wheelbarrow, snowblower and hand-truck wheels — bores of 13.1, 16.3 and 19.5 mm for 1/2", 5/8" and 3/4" axles (12.7 / 15.88 / 19.05 mm), each 25 mm long with a 2.5 mm thrust flange (25.0 / 28.2 / 31.4 mm flange dia). Bodies are 19.0 / 22.2 / 25.4 mm OD with six crush ribs taking them to 21.0 / 24.2 / 27.4 mm, so one bushing presses into any hub bore across that range; a 2.4 mm axial split lets it spring onto the axle and pinch down into an undersize bore, and two internal grease channels keep it fed. Snip the 1.2 mm webs with side cutters and use the size you need — the whole card is 95 x 31 x 27.5 mm.