Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Mower Height Lever Set-Screw Grip
Replacement grip for a push-mower or zero-turn height-adjust lever whose plastic knob has cracked off. It is 90 x 36 x 18 mm and has a 24 x 7.5 mm slot, 50 mm deep, that takes any flat bar up to 24 x 7 mm or round rod up to 7 mm. Two M4 set screws in brass heat-set inserts (5.5 mm bores) clamp it to the bar, so you don't need the exact OEM size.
52 mm Gauge Pod Panel Mount
A single-hole pod for a standard 52 mm (2-1/16") boost, oil-pressure or volt gauge: Ø52.4 mm bore, 36 mm deep, stepping down to a Ø48 mm shoulder that stops the gauge and lets the harness exit straight through the base. The cup sits at 18° on a flat 92 x 78 x 5 mm plate with four M4 clearance holes (VHB-friendly underside), and two M4 heat-set inserts in the flank pads take nylon-tip set screws that lock the barrel — total height about 58 mm, prints on the plate with no supports.
Flagged: automotive electrical. Not for safety-critical use without independent engineering review.
Seat Belt Buckle Webbing Stop Clamp
A one-piece C-clamp that grips a car seat-belt web (47 mm wide, ~1.2 mm thick) so the latch tongue stops sliding down out of reach — the belt slides in sideways through the 2.4 mm slot and two M4x20 screws into M4 heat-set inserts pinch it closed on two grip ribs. 71 x 20 x 26 mm, clamping 26 mm of webbing across its full width.
Hacksaw Blade Jab Saw Handle
A one-piece handle that turns a snapped 12.5 mm hacksaw blade into a jab saw for cutting in tight spots — 148 mm long with a 1.6 mm x 13.5 mm blade slot 55 mm deep, so the blade bottoms out on a solid end stop for push cuts. Two M4 brass heat-set inserts (5.5 mm bores) take M4 set screws that pinch the blade against the far slot wall; the grip is 22 x 26 mm with finger scallops, a hollow ribbed core, and an 8 mm hanging hole for a pegboard hook.
Flagged: a sharp edge or blade. Not for safety-critical use without independent engineering review.