Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Sump Pump Float Cord Zip-Tie Pipe Clamp
Replaces the small plastic clip that snaps off and lets a tethered float switch cord slide down the sump discharge pipe. A 90° V-saddle seats any pipe from 1-1/4 to 2 in (42–60 mm OD), and two zip-tie tunnels lock it to the pipe. A 10 mm top groove with two more tunnels grips float cords up to about 9 mm, so you can set the tether length by sliding the cord before you cinch it. The clip is 40 x 60 x 40 mm and takes standard ties up to 4.8 mm wide.
Dual Size EMT Conduit Snap Hanger
A screw-down wall plate with two snap-in saddles that take 3/4 in EMT (23.4 mm OD, 23.7 mm bore) and 1/2 in EMT (17.9 mm OD, 18.2 mm bore), so a conduit and a small pipe or hose run stacked on one anchor point. Overall 102 x 26 x 25.5 mm; two 4.5 mm holes 84 mm apart take M4 or #8 wood screws, the lips wrap past the pipe centreline for a 0.5 mm one-hand snap, and a dovetail tongue and socket on the ends let hangers gang into a continuous run along a wall or joist.
Pipe Clamp Stabilizer Foot
A drop-on foot for 3/4 in schedule-40 black pipe clamps (26.7 mm OD bar), sized with a 27.2 mm U-channel so the clamp stands upright on the bench instead of rolling over during a glue-up. The 50 x 86 mm base gives a wide anti-tip stance, twin 12 mm shoulder pads at 48 mm hold the workpiece 4.4 mm clear of the bar so squeeze-out never reaches the steel, and a 3.4 mm side hole takes an M4 self-tapping set screw to lock the foot at any point along the pipe. Print two (or four for long bars).