Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Fire Extinguisher V-Cradle Strap Bracket
A wall bracket with a V-shaped cradle that centres any fire extinguisher body from about 70 to 130 mm across, which covers typical 2.5 to 10 lb units. It replaces a cracked OEM strap bracket in a garage, RV, boat or kitchen. The plate is 140 x 42 mm, the arms reach out 50 mm, and it mounts with two #10 or M5 screws through 5.5 mm holes. A 25 mm hook-and-loop strap or 1 in webbing runs through the 27 mm slots at the arm tips. Measure your extinguisher body before you order. For vehicles, fit one near the top and one near the bottom of the body.
Blade Fuse Assortment Tray With Puller Trench
A stepped 130 x 80 mm bench or glovebox tray that holds blade fuses upright by amperage. It has 14 mini slots (4.8 x 12.5 mm), 12 ATO/ATC slots (6.2 x 20.8 mm) and 3 maxi slots (9.8 x 30.6 mm), plus an 11 x 72 mm trench that takes the fuse puller. The slots are cut a little oversize compared with the usual fuse bodies (10.9 x 3.6 mm mini, 19.1 x 5.1 mm ATO, 29.2 x 8.5 mm maxi), so the fuses drop in and stand with their heads up for grabbing. Two 4.5 mm holes let you screw it down with #6 or M4 screws inside a van, RV or electronics cabinet.
Flagged: automotive electrical. Not for safety-critical use without independent engineering review.