Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Screw-Through Cargo Tie-Down Hook
A screw-on J-hook that replaces a snapped cargo-net or tie-down hook in an SUV, wagon or trailer. It has a 70 x 16 mm base flange with two M4 / #8 clearance holes (4.5 mm) on 50 mm centres, and a 15 mm entry throat that takes net loops, bungee hooks and strap hooks. It prints on its side, so the pull from the strap runs along the layers instead of across them.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.
Bungee Cord Seven-Peg Wall Rail
A 160 x 42 x 44 mm wall rail with seven pegs on 22 mm centres. Each peg has a 9 mm flat seat and an 8 mm lip, so a bungee cord's steel hook drops on and stays put instead of ending up in a tangle in a bucket. It mounts with three #8 pan-head or washer-head wood screws through 4.8 mm holes. Each peg is printed as a 6 mm upright fin, so the hanging load runs along the layers and can't peel them apart.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.
Ratchet Strap Drill Winder Spool
A spool that winds loose ratchet straps and tie-downs into a tidy coil instead of a tangled ball: thread the strap tail through the two 3.6 mm slots in the drum and spin it. The 88 mm flanges and 54 mm clear drum take a 2 in (50 mm) strap, the Ø16 mm spindle has a 6.7 mm across-flats socket for a 1/4 in hex bit so a cordless drill does the winding, and an 8.3 mm cross hole takes an 8 mm rod or screwdriver shank as a hand crank.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.