Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Fire Extinguisher V-Cradle Strap Bracket
A wall bracket with a V-shaped cradle that centres any fire extinguisher body from about 70 to 130 mm across, which covers typical 2.5 to 10 lb units. It replaces a cracked OEM strap bracket in a garage, RV, boat or kitchen. The plate is 140 x 42 mm, the arms reach out 50 mm, and it mounts with two #10 or M5 screws through 5.5 mm holes. A 25 mm hook-and-loop strap or 1 in webbing runs through the 27 mm slots at the arm tips. Measure your extinguisher body before you order. For vehicles, fit one near the top and one near the bottom of the body.
2x4 Lumber Rack Arm Socket
A wall bracket that turns a scrap 2x4 into a cantilever lumber-rack arm: the socket takes a nominal 2x4 end (38.1 x 88.9 mm actual) in a 39.2 mm channel, 71 mm deep, with 4.5 mm cheeks that pin the wood with two 5.5 mm cross screws per side. The 8 mm back plate takes four #10 or M5 screws into a stud on a 30 x 48 mm pattern, counterbored 3 mm so the heads clear the lumber. Overall 78 x 48 x 88 mm — print a pair per arm for conduit, moulding, pipe and offcut storage.