Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Motorcycle Helmet Wall Hook With Jacket Hook
A garage wall hook that holds a motorcycle or bike helmet on a 112 mm arm with a raised lip so the helmet can't slide off. A short hook underneath takes a jacket or gloves. It mounts on a stud with two countersunk #10 or M5 screws through 5.5 mm holes. It prints on its side, which puts the load in the layer plane, and the 45° trussed gusset keeps it stiff with about 90 cm³ of plastic. Overall size is 112 × 135 × 24 mm.
Ear Muff And Safety Glasses Wall Hanger
A screw-on wall hanger for hearing protection and eye protection by the saw or grinder. The top saddle is 41 mm deep with an 8 mm lip, sized for an ear-muff headband. The lower hook is 26 mm deep and takes folded safety glasses. It is 135 mm tall and 36 mm wide, and fixes with two #8 wood screws (4.8 mm clearance holes, 9 mm counterbores). It prints on its side so the hook bending load runs along the layers, not across them.
Jumper Cable And Charger Clamp Wall Dock
A screw-to-stud wall dock for jumper cables or a battery charger. The coil hangs in a saddle 62 mm deep, the red clamp grips a 6 mm top tab and the black clamp grips the 8 mm saddle lip, so the cables stop living in a tangled pile on the floor. It's 68 x 112 x 48 mm and prints on its side, which keeps the hanging load in the layer plane. Two horizontal 5.5 mm holes with 10 mm counterbores take #10 (4.8 mm) or #8 wood screws, or M5 bolts.
Flagged: battery or DC power. Not for safety-critical use without independent engineering review.
Vertical Bike Wall Hook With Rim Saddle
Screw-on J-hook that hangs a bike vertically by its front wheel. The rim's spoke bed rests in a curved saddle 85 mm out from the wall, behind a lip 24 mm tall. It mounts to a stud with two #10 (4.8 mm) or M5 screws through countersunk 5.5 mm holes 105 mm apart. The part is 104 x 140 x 22 mm and prints on its side, so the bending load runs along the layers instead of across them.
Screw-On Ladder Rail Wall Hook
A heavy wall hook for hanging a ladder flat on the garage wall. It has a 92 mm deep cradle and a 32 mm retaining lip, so the side rail of a stepladder or a nested extension ladder drops in and can't roll out. Print two and fix each to a stud with #10 (4.8 mm) screws through 5.5 mm holes. It prints on its side, 150 x 112 x 22 mm, so the weight loads along the layers and the tapered truss arm keeps the plastic volume down.