Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
ATO Fuse Tap Zip-Tie Dash Mount
A small cradle that stops an add-a-circuit fuse tap dangling behind the fuse box. A U-channel with a 16 mm inner width holds the tap body and two bridged tunnels in the floor take zip ties up to 5 mm wide. A 3.6 mm comb slot gives the pigtail wire strain relief, and one 4.5 mm hole takes an M4 screw or a #8 (4.2 mm) sheet-metal screw. It is 62 x 24 x 15 mm overall.
Crimp Terminal Gauge Sort Tray
A 148 x 100 x 28 mm tray with 12 bins (34.6 x 30.7 mm each) for sorting crimp terminals. The four columns hold ring, fork/spade, quick-disconnect and butt-splice terminals, and the three rows follow the standard insulation colours: red 22–18 AWG, blue 16–14 AWG, yellow 12–10 AWG. Each row has 1, 2 or 3 dots recessed into the side wall so you can find a gauge at a glance. A 45° ramp at the front of every bin lets you slide a single terminal out with a fingertip.
Flagged: automotive electrical. Not for safety-critical use without independent engineering review.