Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Hose-Clamp Camp Chair Cup Holder
This cup ring clamps onto camp chairs, canopy legs, boat rails or wagon frames made from round tube between 16 and 32 mm. A 90° V-jaw centres the tube and a band tunnel takes a standard 8 mm or 12.7 mm worm-drive hose clamp or a zip tie. The 82 mm bore fits 66 mm cans and most tumblers, which sit on an 11 mm lip with an open 60 mm centre so rain drains straight through. Overall size is 136 x 88 x 40 mm.
Generator Frame Tube Hose-Clamp Foot
This replaces the cracked plastic foot on a portable generator's wheel kit or tube frame. A 90° V-saddle sits on any round frame tube from 19 to 32 mm OD and lifts it 40 mm off the ground. Two 1/2 in (12.7 mm) worm-drive hose clamps strap it on through 13 x 3 mm tunnels. The 70 x 56 mm hollow ring base takes the generator's weight in compression.
Canopy Leg V-Block Guy-Line Anchor
A 90° V-block that straps to a pop-up canopy or gazebo leg with a worm-drive hose clamp or strap through its two 14 x 3.5 mm band tunnels. It adds a ribbed tab with a 10 mm hole for a guy line or sandbag, so wind load goes to the ground and not into the plastic corner joints that tend to snap. The V seats round legs from 19 to 32 mm and 25 mm square legs set corner-in. The block is 56 mm tall and 36 mm wide, and the tab reaches 67 mm.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.
Round Tube Gate Latch Adapter Saddle
A V-saddle that clamps onto a round metal or PVC gate tube from 19 to 45 mm OD, including 3/4 in EMT (23.4 mm), 1 in PVC (33.4 mm), 1-3/8 in (34.9 mm) and 1-5/8 in (41.3 mm) chain-link frame tube. It's held with two 1/2 in worm-drive hose clamps threaded through built-in band tunnels, and gives you a flat 56 x 64 mm face you can screw a wood-gate drop or slide latch onto. That way the latch doesn't need a flat wooden rail. Mount the latch between the two bands with screws up to 16 mm long, or no longer than 10 mm on the side wings.
Twin-Band Downspout Wall Standoff
This is a wall-mounted standoff block for a gutter downspout. It measures 130 x 60 x 11 mm and screws on with two #10 or M5 screws (5.5 mm countersunk holes). Two 14 x 3.5 mm tunnels run through it for zip ties or 1/2 in (12.7 mm) worm-drive hose-clamp bands. The band wraps around the downspout, so one part fits 2x3 in (about 51 x 76 mm nominal), 3x4 in or any other profile, and it replaces the brittle vinyl straps that snap every winter.