Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Plant Support Ring Clamp For 1/2 in EMT Stake
A pinch-clamp collar for 1/2 in EMT conduit (17.9 mm OD, 18.4 mm bore) that holds an open 70 mm plant ring. You slip the ring around a tomato, pepper or dahlia stem through the 20 mm gate, then lock it at any height with an M5 bolt and a captured nut. The part is 130 mm long and prints flat, so the side load from the plant stays along the layers instead of across them.
3/4 in PVC Poultry Waterer Pipe Hanger
This screw-on hanger clamps a 3/4 in Schedule 40 PVC nipple-waterer pipe (26.7 mm OD) to a coop post or run frame. An M4 pinch bolt with a captive nut stops the pipe from rolling, so the nipples keep pointing straight down and don't drip. Vertical 5.2 mm slots fit #8 or #10 screws (4.2–4.8 mm shank) and give 5 mm of height adjustment for levelling the line. The part measures 62 x 80 x 16 mm and the pipe weight loads it along the layer plane.
Snow Shovel D-Grip Clamp Handle
A replacement D-grip for snow shovels and garden tools with a 1-1/8 in (28.6 mm) wood or fiberglass shaft. It has a 29.1 mm socket, 47 mm deep, with a split top that two M5x20 bolts and captured nuts pinch shut. A #8 wood screw goes up through the bottom into the shaft to stop it from twisting. The grip opening is 86 x 62 mm, big enough for a gloved hand, and it's printed flat so pushing and pulling loads run along the layers, not across them. For 1 in (25.4 mm) shafts, set BORE to 25.9.