Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Chain-Link Gate Wheel Clamp Fork
This bolt-on wheel fork for swing gates clamps around the 1-3/8 in (34.9 mm OD) vertical frame tube of a chain-link gate. Two M5 pinch bolts close it on the tube, and captive-nut pockets hold the nuts. It carries a caster wheel up to 32 mm wide on an 8 mm steel pin. There are two axle heights: one for 50 mm (2 in) wheels and one for 76 mm (3 in) wheels. An M3 grub screw locks each pin. Use it to replace a rusted or cracked factory gate-wheel bracket without buying a whole wheel assembly.
46-49 mm Chain-Link Brace Band
A clamp-on brace band for odd-size chain-link post pipe from 46 to 49 mm OD (1-7/8 in 47.6 mm pipe and 1-1/2 in 48.3 mm pipe), the sizes big-box stores don't stock. The 49 mm bore can tighten up to 8 mm around the post. A 9 mm cross-hole with a recessed square seat takes a standard 5/16 in carriage bolt to hold a rail-end cup or tension bar. The band is 25 mm tall with a 5 mm wall. Print it in PETG or ASA for outdoor use.
1 in PVC Snap-In Fence Standoff Clip
Snap-in saddle clip for 1 in schedule 40 PVC (33.4 mm OD). The pipe pushes through a 28 mm mouth into a 33.6 mm cradle, and the clip holds it 12 mm off a fence, post or wall so wood can dry behind the run. It suits irrigation, solar conduit and garden hoop runs. The 70 x 20 mm foot takes two #10 wood screws (5.3 mm clearance holes on 56 mm centres), and the ring prints flat so any pull on the pipe goes along the layers.
Chain-Link Gate Fork Latch
Replacement fork latch for a residential chain-link gate: a split collar clamps the 1-3/8 in (34.9 mm) gate frame upright with two M5 bolts, and a tapered V-fork reaches 72 mm across to self-centre on any 1-5/8 in to 2-3/8 in (41.3–60.3 mm) latch post. A 6.4 mm cross hole through both jaws takes a 6 mm pin, hitch clip or padlock shackle so the gate can be locked shut. Overall 129 x 62 x 26 mm; print in PETG or ASA for UV life.