Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Resin Shed Through-Bolt Shelf Bracket
A trussed shelf bracket for resin or plastic sheds, where screws won't hold in the thin wall. It mounts with two M5 through-bolts (5.5 mm clearance holes, 79 mm apart) using a washer on the outside. The arm is 140 mm long and 20 mm wide, takes a board through two #8 wood-screw pilots (3.2 mm), and has a 6 mm front lip that keeps the board from sliding off. It prints on its side so the shelf load runs along the layers, not across them.
Keter Resin Shed Bolt-Through Door Handle
Replacement D-handle and matching backing plate for Keter-style resin shed doors whose moulded centre-bracket handle has snapped off; drill two 9 mm holes through the door, sandwich the broken moulding between handle and plate, and bolt through. The handle is 132 mm wide and 18 mm tall with a 13 mm grip standing 47 mm off the door, and both parts carry 8.5 mm holes at 108 mm centres for M8 or 5/16 in bolts and washers (M6 fits loosely); the 26 mm wide backing plate ships joined by two snap-off sprues. Print in ASA or PETG for sun exposure.
Resin Shed Door Slotted Replacement Hinge
A 96 mm print-in-place butt hinge to replace broken plastic hinges on resin garden sheds and storage boxes. Each 44 mm leaf has two 5.5 x 12 mm slotted holes so it fits existing screw positions, plus a round 5.5 mm centre hole for an M5 bolt or #10 screw. The 14 mm knuckles turn on a fused 6 mm pin with 0.5 mm clearance, so it prints assembled with no supports.