Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
1/2 in PVC Low Tunnel Hoop-To-Ridge Cross Clip
A snap-on cross clip that joins a 1/2 in schedule 40 PVC ridge pole (21.3 mm OD) to the crown of each 1/2 in PVC hoop in a garden low tunnel. The two pipes sit at right angles with no glue or drilling. The ridge pole snaps into a C-ring with an 18 mm mouth, and the hoop presses down into a 21.7 mm U-cradle with a 19 mm throat. Two 4 mm zip-tie tunnels under the cradle let you strap the hoop down so wind can't lift it out. The part measures 30 x 59 x 25 mm.
Holiday Light Gutter And Shingle Clip Strip
A breakaway strip of four all-in-one holiday light clips for C7/C9 and mini strings. Each clip has a 26 mm spring-leaf pinch jaw: it snaps onto a gutter lip (0.6 mm grip bump) or slides under a shingle tab (opens to about 4 mm). The cord drops into a 7 mm C-ring with a 3 mm snap mouth. Use them when the old set's clips have gone brittle or missing. The clips print on their sides, so the leaf bends along the layers rather than across them.
1-3/8 in Top Rail Chain-Link Snap Tie
A tool-free, reusable tie that snaps over a standard 1-3/8 in (34.9 mm) chain-link top rail. It replaces the twisted wire ties that rust and work loose. The 35.4 mm C-ring wraps 240° around the rail, and a flexing 4 mm hook on the side snaps over one strand of 9–11 gauge mesh wire (3.0–3.8 mm) to hold the fabric tight against the rail. The clip is 14 mm tall and prints flat with no supports.
1/2 in PVC Row Cover Hoop Snap Clip
A 40 mm-long C-clip that snaps over 1/2 in Schedule 40 PVC hoops (21.3 mm OD) and holds frost cloth, insect netting or greenhouse film tight against the pipe. The 22 mm bore leaves room for the fabric, flared lips help it snap on, and a rear fin with a 6 mm eye takes twine or a sod staple to tie the cover down.