Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Raccoon-Proof Bin Lid Snap Latch
A latch that bolts to the outside of a trash or storage bin and holds the lid down. A 3 mm flexing beam with a 10 mm catch tooth snaps over the lid edge, and a pull tab lets a human open it. Two M5 bolts go through a 36 mm wide, 6 mm thick back plate, and each bolt column has three holes (24, 32 and 40 mm up) so you can match the height of your lid rim.
RV Bay Door Snap Hold-Open Catch
A two-piece snap catch that holds an RV or trailer storage bay door open in the wind. A 9.6 mm knob on the door stud snaps through an 8.2 mm flexing fork mouth on the wall catch. Both parts are 60 x 20 mm mounting bars with two 4.6 mm holes on 44 mm centres, for #8 wood screws or M4 bolts and nuts. It prints already snapped together.
Screw-On Cooler Lid Snap Latch Set
A screw-on replacement for a snapped Igloo or Coleman-style cooler latch. A 40 x 16 x 10 mm lid pad holds a 24 mm wide, 3 mm thick flex arm that drops 58 mm down the cooler wall. Its 4.5 mm ramp tooth snaps under a separate 36 x 16 x 6 mm keeper plate. Both pieces take #8 wood screws: the pad has 4.6 mm slots with 6 mm of height adjustment, and the keeper has counterbored 4.6 mm holes. They print together on breakaway tabs, so a cooler with a good body but a broken latch can be put back in use.
Downspout Elbow Snap-In Wind Clip
This wall clip replaces the factory clip that wind snaps off a folding downspout elbow. Two flexing arms and ramped hooks snap around rectangular "2x3 in" downspout up to 80 mm wide, and a built-in bow spring presses spouts 50–60 mm deep forward against the hooks so they don't rattle. The clip is 130 x 82 x 25 mm and fixes to the wall with two #8 screws through 4.5 mm holes in the side wings. It prints flat without supports, and the arms flex within the layers, so wind load never pulls across the layer lines.
2 in Hitch Ball Snap-On Weather Cap
A snap-on cap for a standard 2 in (50.8 mm) trailer hitch ball. It keeps rain, grit and grease off the ball, and off your trouser legs. Six slotted fingers flex over the ball's equator and close to a 47.6 mm lip underneath to hold on. It stands 62 mm tall and is 56.8 mm across. The 45° roof prints without supports and sheds water, and a 5.5 mm lanyard eye on top lets you tie it to the safety chain so it doesn't go missing.
Kayak Deck Paddle Park Clip
A snap-in deck clip that parks a kayak or canoe paddle shaft (30 mm nominal, grips 28–31 mm) against the hull so it stays put while you fish or land — the OEM clip sun-rots and no maker sells it separately. 76 x 30 x 38 mm: 6 mm base plate with two M5 clearance holes at 38 mm spacing for well nuts, plus two 8 x 14 mm lash slots at the ends so it can be strapped to 6 mm deck bungee with no drilling into the hull.