Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Snowblower Sled-Runner Skid Shoe
A replacement skid shoe for a snowblower auger housing. It has a 130 mm sled runner, 22 mm wide and 7 mm thick, that turns up at both ends so it glides over gravel and pavement cracks instead of digging in. The two vertical adjustment slots are 9 mm wide, fit 5/16 in or M8 bolts, sit 70 mm apart by default and give 21 mm of height travel. Measure your old shoe's hole spacing and set BOLT_SPACING to match it.
Snowblower Chute Crank Rod Guide
This replaces the snapped eyelet that holds a snowblower's chute-rotation crank rod against the handle. A 90° V-saddle sits on any 19–32 mm handle tube and is held by two zip ties (up to 5 mm wide) that run through tunnels in the saddle. The 14 mm guide eye takes crank rods up to 12 mm, about 38 mm from the tube. Overall size is 40 x 66 x 24 mm. Print it in PETG for winter use.