Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Bar Load Cell Riser Mount With Overload Stop
This is a cantilever base for the bar-type strain-gauge load cells used with HX711 boards. A 40 x 30 mm riser holds the fixed end 20 mm above a 110 x 50 mm plate. Its 5.5 mm slot, with a hex-nut track underneath, takes M4 or M5 bolts in a 15–26 mm pattern, so you don't need a matching bracket. Under the free end is an M4 heat-set overload-stop post: a screw in it sets the gap so a dropped weight can't over-bend the cell. The plate fixes down with four 4.5 mm (M4 / #8) holes.
Hairpin Desk Leg Stripped-Screw Repair Plate
Fixes a hairpin or plate-mount desk leg whose wood screws have stripped out of the tabletop. The 110 x 110 x 7 mm plate goes on fresh wood with eight #8 wood screws (4.8 mm holes) set on tabs 144 mm across, clear of the old holes. The leg's steel plate then bolts on with M4 bolts and nuts that slide in four diagonal nut tracks (7.4 mm wide), so any hole pattern from about 3 in to 4.5 in square fits.