Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Chest Freezer Basket Hanger Bracket
A replacement end hanger for a chest freezer wire basket. Its 6 mm wide cradle holds the basket's top rail wire (anything up to about 5.5 mm thick) and is locked on with two zip-tie slots that take ties up to 4.8 mm wide. A 35 mm foot with a stop lip sits on the freezer's inner ledge and holds the basket about 45 mm below it, so a basket with a snapped hanger works again without buying a whole new basket. The part is 45 x 56 x 20 mm and prints flat, so the basket's weight bends it along the layers instead of pulling them apart.
Slotted-Span Fridge Door Pull Handle
A 170 mm replacement pull handle for a refrigerator or freezer with a cracked or snapped handle. The two feet have 10 mm slots for M4 or #8 screws, so it fits screw spacings anywhere from 136 to 156 mm without drilling new holes. The bar stands 26 mm off the door to leave room for your fingers, and the screw heads sit in 9 mm counterbore channels you reach from the front. It prints flat, so the pulling force runs along the layers instead of across them.
150 mm Microwave Turntable Roller Ring
Replacement microwave turntable support ring for ovens whose glass tray rides on a 150 mm roller track. It has three 18 mm rollers on radial pins, a 168 mm OD ring and a loose 36 mm hub that drops over drive couplers up to about 34 mm. The ring, rollers and pins are all PLA with no metal inside. They print together on breakaway sprues: snap them off, drop each roller between its cheeks and push the headed 4 mm pin through, where the inner cheek grips it. The tray sits 18 mm above the floor and the ring clears it by 2.5 mm.
Universal Toaster Lever Slide-On Knob
This knob replaces a broken toaster lever knob. It is 36 x 26 x 18 mm, with a cross-shaped socket that takes a flat steel lever tab up to 12.5 x 3 mm or a round stem up to 6 mm, and an M3 heat-set insert and grub screw clamp it to whichever one your toaster has. OEM lever knobs are usually discontinued, and this one means you don't have to throw out a working toaster over a snapped piece of plastic.
Fridge Door Hinge Pin Socket Plate
A screw-on repair plate that gives a sagging refrigerator or freezer door a fresh hinge-pin socket when the moulded nylon pocket has worn oval. The 72 x 52 x 5 mm plate carries a ribbed 22 mm boss with an 8.3 mm slip-fit socket 12 mm deep for a standard 8 mm hinge pin, a 22 mm x 2 mm relief recess underneath so it sits flat over the chewed-up original boss, and four 4.5 mm holes on a 56 x 38 mm pattern for #8 screws or M4 bolts.