Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Four-Radius Cast Iron Pan Scraper
This is a 90 x 70 mm pan scraper for cast iron and stainless cookware. The bottom 1.2 mm stays straight and the edge then bevels in to a 6 mm grip ring. One long straight edge cleans flat pan bottoms. The four corners have 2, 8, 16 and 28 mm radii, so the right one fits a grill-pan groove, a saucepan corner, a skillet wall or a dutch oven, and you can scrape stuck food off without steel wool. There is a 22 mm finger hole and a 7 mm hang hole. Use it only once the pan has cooled to warm (PLA softens around 60 °C), or order it in PETG.
Universal Pot Lid Knob Replacement
A drop-in replacement knob for a glass or metal pot lid whose original knob has cracked, melted or gone missing: Ø46 mm heat-shield flange, 33 mm tall six-flute grip, and a Ø5.5 x 12 mm bore for an M4 brass heat-set insert so the lid's own screw threads into metal. Cored out to about 18 cm³, prints flange-down with no supports — print it in PETG or ASA, not PLA, since lid knobs sit above a hot pan.
Clip-On Pot Rim Pasta Strainer
A hook-on straining shield that clamps over the rim of a 20–26 cm (8–10 in) pot so you can pour off pasta or vegetable water without a colander. A continuous 45° hook lip and 7 mm rim throat grab any rolled rim anywhere along its 117 mm arc, twelve 3.5 mm radial slots pass water but hold pasta, and a 26 mm thumb pad lets you press it down through an oven mitt while pouring. Overall 117 x 73 x 18 mm — print in PETG or PP for boiling-water contact.
Flagged: contact with food. Not for safety-critical use without independent engineering review.