Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Pull-Down Faucet Hose Split Weight
A two-piece weight that bolts onto the hose of a pull-down kitchen faucet, under the sink, so the sprayer pulls back into its dock again. It replaces the weight that slides off or gets lost and isn't sold on its own. Print two identical 80 x 40 x 16 mm halves. They fit braided hose of about 9–11 mm OD with grip ribs and close with four M4 x 25 cap screws and nuts. Two sealed 8 x 44 mm pockets inside hold steel BBs or scrap nuts set in hot glue to add weight.
Pull-Down Faucet Sprayer Cone Dock
This screw-on cone cradle holds a pull-down or side-spray faucet head that has lost its snap-in dock. It works with any head whose hose end is 20 to 52 mm across. The hose drops in through an 18 mm front slot and a 20 mm bottom opening, then the head sits nose-up in the 45 mm deep cone. Mount it on a backsplash or cabinet side with two or four #8 wood screws through 5.0 mm holes in the 70 x 60 mm back plate.