Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Onigiri Triangle Rice Mold With Plunger
This is a two-piece onigiri mold that prints in one job. It has a bottomless triangular frame, 40 mm tall with an 80 mm inside edge and rounded corners, and a fitted plunger that prints nested inside the frame with a 0.5 mm gap. To use it, pack rice into the frame and press the knob to shape the rice ball and push it out in one firm triangle, with no rice stuck to your hands and no plastic wrap.
Flagged: contact with food. Not for safety-critical use without independent engineering review.
6 mm Pin Cherry And Olive Pitter
This countertop pitter takes cherries and olives and uses a plain 6 mm stainless dowel pin about 100 mm long as the plunger. The pin slides through a 26 mm guide boss with a 6.3 mm bore and pushes the pit through a 10 mm hole in a 20 mm cup-shaped seat, and the pits fall into a 24 x 13 mm chamber that you empty by tipping it out the front. The block is 60 x 50 x 90 mm and the arch over the seat has a 45° roof, so it prints without supports.
Flagged: contact with food. Not for safety-critical use without independent engineering review.
Three-Lane 60° Taco Fill-And-Serve Stand
A stand with three V-shaped lanes that holds hard or soft taco shells upright while you fill and serve them. It also holds pitas, hot-dog buns and rolled wraps. Each lane has 60° walls, a 10 mm flat bottom and a 52 mm opening at the top. The stand measures 171 x 60 x 40 mm. It is a ribbed shell with hollow tunnels under each ridge, so it uses about 75 cm³ of plastic, prints with no supports and won't tip over when the shells are loaded.
Flagged: contact with food. Not for safety-critical use without independent engineering review.
Bagel Halving Knife Guide Cradle
This cradle holds a bagel on its edge in a 48 mm wide channel. Slots in both end walls and a groove in the floor keep a bread knife on the centre line, so the bagel splits evenly and your fingers stay out of the blade's path. It is 140 x 56 x 50 mm and fits bagels and English muffins up to about 130 mm across and 46 mm thick. The side walls have windows to save material, and the floor is open at the ends so crumbs drop out when you tap it.
Flagged: contact with food. Not for safety-critical use without independent engineering review.
Mandoline Slicer Food Holder Guard
A replacement hand guard for a mandoline slicer — the pusher everybody loses — with 15 tapered spikes that impale a potato, onion or courgette and a 76 mm skirt that keeps fingers off the blade. 90 mm grip flange, 6 finger ribs, 27 mm tall, 22 mm deep food pocket, prints spike-side-up with no supports.
Flagged: contact with food. Not for safety-critical use without independent engineering review.