Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Pull-Tab Can And Jar Lid Lifter Lever
A 124 mm flat-printed lever with a tapered wedge tip, 1.6 mm thick at the point, that slides under a ring-pull tab. A 12 x 6 mm catch window holds the tab ring so you can lift it without using your fingernails. The same tip also pops the vacuum seal on jar lids. It helps with stubborn soup, pet-food and soda cans, and suits anyone with weak or sore hands. The lever lies flat on the bed, so prying loads run along the layers, and a 10 mm hang hole in the handle lets you keep it on a hook.
Step Can Pedal Rocker Arm
Replacement rocker/bell-crank arm for the foot-pedal linkage in a step trash can (Simplehuman-style 30 L round cans and their clones), the one plastic lever that always snaps and that nobody sells as a service part. 98.7 mm long with a 5.5 mm pivot bore for a 5 mm pin or M5 bolt, two 4.5 mm pedal-rod holes 9 mm apart to re-tune pedal throw, and an open C-socket at the lift end that clips over a 4 mm lid rod; 10 mm tall bosses and a full-length spine rib carry the load in the print plane. Measure your can's pivot pin before printing — holes are sized to standard 4 mm / 5 mm pins.