Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Tuna Can Palm-Knob Drain Press
A 79 mm perforated press disk with a 34 mm palm knob. It drops inside a standard 3 in tuna, chicken or pineapple can (about 83–87 mm inside the rim, so there is a 2–4 mm gap all round) and squeezes the liquid out through 36 drain holes (3.5 mm) without you holding a sharp lid. Four radial ribs keep the 3.5 mm disk flat under palm pressure. It prints flat with the pressing face down, so it needs no supports.
Clip-On Pot Rim Pasta Strainer
A hook-on straining shield that clamps over the rim of a 20–26 cm (8–10 in) pot so you can pour off pasta or vegetable water without a colander. A continuous 45° hook lip and 7 mm rim throat grab any rolled rim anywhere along its 117 mm arc, twelve 3.5 mm radial slots pass water but hold pasta, and a 26 mm thumb pad lets you press it down through an oven mitt while pouring. Overall 117 x 73 x 18 mm — print in PETG or PP for boiling-water contact.
Flagged: contact with food. Not for safety-critical use without independent engineering review.