Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Push-In Tea Towel Pinwheel Grip
This is a screw-on tea towel grip for a cabinet end or the side of an island. Push a corner of the towel into the centre and six angled flex fins pinch it, so no hook or ring is needed. The 90 x 50 mm back plate has two countersunk 4.8 mm holes, 72 mm apart, for #8 (4.2 mm) wood screws. The 50 mm cup stands 24 mm off the plate. The fins print upright, so they bend along the layers instead of peeling them apart.
Under-Cabinet Screw-On Banana Hook
This hook screws under a kitchen cabinet so bananas hang in the air instead of bruising on the counter. The 92 mm flange takes two #8 wood screws (4.2 mm shank) through 4.6 mm holes set 80 mm apart. A gusseted 8 x 20 mm stem drops the 22 mm hook throat 80 mm below the cabinet, and the part prints on its side so the load runs along the layers.
Under-Cabinet Three-Mug Hook Rail
A 150 mm rail that screws to the underside of a kitchen cabinet or shelf with two #8 wood screws (4.5 mm clearance holes, 50 mm apart). It hangs three mugs on J-hooks set 50 mm apart, each with a 14 mm handle gap. It prints on its side, so the mug load pulls along the layers and doesn't split them apart, and gussets at each hook root stop the hooks from snapping off.