Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Banded Dry-Goods Bag Pour Spout
A pour spout that fits into the gathered neck of a flour, rice or pet-food bag. You hold it on with a zip tie or rubber band in the 45° V-groove around the 42 mm gather tube. The 30 mm pour bore has a beaded lip and a push-in plug cap, which is printed in one piece with the spout and joined to it by a flexible 1.2 mm strap so it can't get lost.
Chest Freezer Basket Hanger Bracket
A replacement end hanger for a chest freezer wire basket. Its 6 mm wide cradle holds the basket's top rail wire (anything up to about 5.5 mm thick) and is locked on with two zip-tie slots that take ties up to 4.8 mm wide. A 35 mm foot with a stop lip sits on the freezer's inner ledge and holds the basket about 45 mm below it, so a basket with a snapped hanger works again without buying a whole new basket. The part is 45 x 56 x 20 mm and prints flat, so the basket's weight bends it along the layers instead of pulling them apart.
Under-Sink Inline Water Filter Bracket
A wall/cabinet bracket that holds a standard 2 in inline water filter (fridge ice-maker, RO post-filter, whole-line carbon) off the plumbing instead of letting it hang on the tubing and kink the push-fits. Twin 90° V-block saddles self-centre any 45–56 mm filter body and a 4.8 mm zip tie through each saddle straps it down; snap-in end clips route 1/4 in (6.35 mm) OD tubing, and four 4.5 mm holes take #8 wood or M4 screws. 130 × 48 × 34 mm, prints flat with no supports.