Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Undermount Sink Jack-Screw Rim Clip
A replacement clip for an undermount kitchen sink, 70 x 20 x 18 mm. The nose presses the sink flange up against the counter. A 7 x 24 mm slot takes the countertop's existing 1/4 in or M6 stud or screw, and an M4 heat-set insert lets a jack screw in the heel set the height, so one clip fits any rim thickness. It prints on its side so the clamping load runs along the layers. Print 6–10 clips in PETG to re-hang a sagging sink.
Pantry Shelf Can Fence Label Clamp
A 50 mm wide clamp that fits over the front edge of a pantry or cabinet shelf. It adds a 30 mm fence so cans and jars can't roll off, and has a slide-in label channel (1 mm slot, 22 mm visible window) on the front. The jaw opens to 20 mm and an M4 thumb screw in a heat-set insert from below tightens it, so it fits any shelf from 12 to 19 mm thick (5/8 and 3/4 in melamine or plywood) with no drilling.
Oven Door Handle Clamp-On Towel Hook
A towel hook that screw-clamps onto any round oven or dishwasher door bar from 16 to 30 mm across, so it can't slide off. A 90° V-crown sits on top of the bar and an M4 bolt in a heat-set insert (5.5 mm bore) pushes up from below to lock it. It is 16 mm wide and about 75 x 101 mm overall, and needs about 24 mm between the bar's centre and the door.
Universal Pot Lid Knob Replacement
A drop-in replacement knob for a glass or metal pot lid whose original knob has cracked, melted or gone missing: Ø46 mm heat-shield flange, 33 mm tall six-flute grip, and a Ø5.5 x 12 mm bore for an M4 brass heat-set insert so the lid's own screw threads into metal. Cored out to about 18 cm³, prints flange-down with no supports — print it in PETG or ASA, not PLA, since lid knobs sit above a hot pan.
Sous Vide Circulator Rim Clamp
Replacement pot clamp for a sous vide circulator whose OEM plastic clamp has snapped — a 38 x 80 x 46 mm C-clamp that hooks over any pot wall or Cambro/Rubbermaid tub rim up to 18 mm thick and locks down with an M4 thumbscrew running in a 5.5 mm heat-set insert bore. A 90° V-channel cradles any circulator barrel from 40 to 70 mm diameter and two 9 x 4 mm slots take a zip tie or velcro strap to bind the barrel into the V. The C-profile lies in the bed plane so the clamping load runs along the layer lines, not across them.