Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Three-Cell Draining Cutlery Caddy
This is a freestanding cutlery basket to replace the one that cracked or went missing from a dish rack. It measures 100 x 70 x 100 mm and has three 31 mm cells for forks, knives and spoons. Water drains through 5 mm holes in the floor into four underfloor channels that open out both sides, and vertical slots in the front and back walls let air through so the cutlery dries instead of sitting in a puddle.
Dishwasher Slotted Countertop Mount Bracket
This replaces the snapped anchor tab that keeps an under-counter dishwasher from tipping forward when you pull out a loaded rack. It is a gusseted L-bracket, 55 x 45 mm and 22 mm wide, with 4.5 mm legs. Each leg has a 5 mm slot about 20 mm long that takes #8 (4.2 mm) or #10 (4.8 mm) screws, so it lines up with the dishwasher's existing frame hole and with the underside of the countertop or the cabinet side.
Zip-Tie V-Cradle Kickboard Leg Clip
A replacement plinth clip that screws to the back of a kitchen kickboard with two #8 wood screws. A 90° V-cradle then holds any round cabinet leg from 25 to 40 mm in diameter, and a zip tie through the two diamond tunnels locks it on. Because it isn't tied to one brand's groove profile, it works on any round leg. The part is 76 × 40 × 27 mm, and the vertical screw slots give ±5 mm of height adjustment.
Mandoline Slicer Food Holder Guard
A replacement hand guard for a mandoline slicer — the pusher everybody loses — with 15 tapered spikes that impale a potato, onion or courgette and a 76 mm skirt that keeps fingers off the blade. 90 mm grip flange, 6 finger ribs, 27 mm tall, 22 mm deep food pocket, prints spike-side-up with no supports.
Flagged: contact with food. Not for safety-critical use without independent engineering review.