Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Sink False-Front Tip-Out Sponge Tray
This 150 x 55 x 60 mm tray screws to the back of the fake drawer front below a kitchen sink, so a tip-out sink panel can hold a sponge and a brush out of sight. It has two compartments, raised drying ribs and front vent slots for airflow. The 4.5 x 14 mm vertical slots in the 3 mm back plate take #6 (3.5 mm) or #8 (4.2 mm) wood screws and let you slide the tray up or down 10 mm to clear the tip-out hinges.
Cabinet Door Damper Screw-Clamp Mount
This surface-mount block lets you add a cheap push-in soft-close damper to an old kitchen cabinet without drilling into the edge of the face frame. A 90° V-tunnel grips any damper barrel from 8 to 12 mm, and two M4 screws threaded into 3.4 mm pilot holes clamp it down. Four 4.2 mm slots for #6 wood screws let you slide the 46 x 44 x 27 mm block ±4 mm so the plunger meets the door.
3 in To 96/128 mm Pull Upgrade Backplate
This backplate covers the old holes when you swap 3 in (76.2 mm) kitchen cabinet pulls for 96 mm or 128 mm pulls, so you don't have to fill and repaint the door. The plate is 160 x 32 x 3.5 mm with 4.5 mm clearance holes at 96 and 128 mm centres (they take M4 or #8-32 pull screws), and the V-notches on both edges line up with the door's centre line. It also works as the drilling template for the new holes.