Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Kitchen Trash Can Bag Rim Lock Clip
A 40 x 20 x 25 mm snap clip that holds a trash bag over the rim of a kitchen bin, so the liner stops slipping down into the can. It prints flat, so its flexible outer leg bends in the strong layer plane. The mouth is 6 mm wide and closes to a 2 mm barb, so it grips rims about 1.5–5 mm thick with the bag film folded over. Ridges on the inner leg bite into the bag, and a thumb tab pries it off.
Step Can Pedal Rocker Arm
Replacement rocker/bell-crank arm for the foot-pedal linkage in a step trash can (Simplehuman-style 30 L round cans and their clones), the one plastic lever that always snaps and that nobody sells as a service part. 98.7 mm long with a 5.5 mm pivot bore for a 5 mm pin or M5 bolt, two 4.5 mm pedal-rod holes 9 mm apart to re-tune pedal throw, and an open C-socket at the lift end that clips over a 4 mm lid rod; 10 mm tall bosses and a full-length spine rib carry the load in the print plane. Measure your can's pivot pin before printing — holes are sized to standard 4 mm / 5 mm pins.