Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Sink Plug Parking Peg With Chain Notch
A wall-screwed peg that holds a loose sink or bath plug off the basin. The 25 mm peg with its 18 mm up-turned lip holds the plug, and a 3 mm notch in the lip catches the bead chain. The 30 x 75 mm plate takes two 4.5 mm countersunk holes for #6/#8 wood screws or M4, and a 45° rib under the peg carries the load across the layers.
Stand Mixer Attachment Wall Hook Rack
A 150 x 62 mm wall or cabinet-door rack with three rising 12 mm hook fins that hang a stand mixer's flat beater, whisk and dough hook by their open frames, with an 8 mm lip that keeps them from sliding off. It mounts with two #8 wood screws (4.8 mm clearance holes, 50 mm apart). It prints upright with the fins doubling as feet, so the hook arms take load inside the layers.
Cast Iron Skillet Handle-Hole Wall Hook
A gusseted wall hook for hanging a cast iron skillet or griddle by its handle hole. The tip is 14 x 12 mm, so it goes through any handle hole at least 15 mm across. The arm gives 56 mm of reach and ends in a 12 mm up-lip that keeps the pan from sliding off. The hook prints on its side, so the pan's weight bends it along the layers rather than across them. It mounts through the 90 mm tall back plate with two #8 (4.2 mm) pan-head wood screws in 5 mm clearance holes.